Fiberlock IAQ 6100 Clear

Fiberlock IAQ 6100 Mold Resistant Coating

Resists mold growth on the dry coating surface.

Product Description

IAQ 6100 is a clear, durable, flexible, and permeable 100% acrylic water based coating. IAQ 6100 has been tested by independent and certified laboratories to prove resistance to mold growth on the surface of the coating, and has successfully passed both ASTM G-21 and ASTM D-3273 mold resistance testing with the highest scores possible. IAQ 6100 is recommended for use on wood, plaster, wallboard, plaster board, concrete, masonry block, primed metal and galvanized metal. IAQ 6000 can also be used on new structural materials during building construction.

SURFACE PREPARATION

Surfaces to be coated must be free of dust, mildew, mold, dirt, grease, loose paint, oil, glue size, calcimine, wax, soap and other surface contamination. Clean mold stained surfaces with Advanced Peroxide Cleaner.

Patch irregularities with vinyl patching paste or an appropriate patching compound. IAQ 6100 is self-priming over bare sheetrock, composition board, ceiling tile and concrete.

WALLBOARD, PLASTER BOARD, GYPSUM BOARD- Joint cement should be sanded smooth, but avoid abrading the paper.

FERROUS METAL- Clean, then prime with IAQ 4000 rust inhibiting direct-to-metal primer.

WOOD- Seal knots and stains with IAQ 5000 stain-blocking primer.

MASONRY BLOCK- Apply one coat of IAQ 3000 block filler if a denser surface is desired.

APPLICATION TOOLS

Apply IAQ 6100 with brush, roller or airless spray equipment.

Brush: Synthetic, nylon or polyester bristle
Roller: Synthetic fiber 3/8”nap or longer

Spray Settings

Pressure: 2000-3000 P.S.I. Tips: .019 to .021 tips

PRODUCT APPLICATION

IAQ 6100 is supplied ready to use, but can be thinned sparingly with water (up to 80mL water per litre) for proper application consistency if necessary. Apply IAQ 6100 generously and uniformly by brush, roller, or airless spray. Apply one coat of IAQ 6100 and ensure that the finished surface is properly sealed. To ensure that the finished surface is properly sealed, two-coats may be required on some porous surfaces.

COVERAGE

Smooth Surfaces- 9-16 sq. metres. per litre

Porous Surfaces- 4-8 sq. metres. per litre

Properties

Product Specifications

Solids by Weight ± 2%:                         54.6%

Solids by Volume ± 2%:                        39.6%

Viscosity at 70°F:                                   90-95 Kreb Units

Specular Gloss:                                     Units 6o ± 1 @ 60o

Calculated VOC:                                     65 grams/liter

Flash Point:                                            Non-combustible

Shelf Life:                                               36 months minimum

Coverage

Smooth Surfaces:                                    6.5-11 sq. metres. per litre

Porous Surfaces:                                     4-8 sq. metres. per litre

Drying Times (@ 21°C , 50% R.H.)

To Touch:            1 hour
To Recoat:            4 hours
Minimum Application Temp: 10 degrees C

Click here to view Product Brochure